Visited product

915Mhz ArduFlyer V2.5.2 UAV Autopilot System(SP Version)

915Mhz ArduFlyer V2.5.2 UAV Autopilot System(SP Version)

Price: $84.99

Item: UAV-APM915-S

Weight: 200g

Arduflyer Soldered Side Pin version

Off the shelf

915Mhz ArduFlyer UAV GPS Flight Control System(Arduflyer Soldered Side Pin version)



APM 2.5 Hardware ArduPilot Firmware Rctimer ArduFlyer Tutorials & Discussion:

 Part  1  
 Part 2:  
 Part 3  
 Part 4   


The ArduFlyer is a complete open source autopilot system. Its design come from 3DRobotics and it 100% compatible with APM2.5.2. It allows the user to turn any fixed, rotary wing or multirotor vehicle (even cars and boats) into a fully autonomous vehicle; capable of performing programmed GPS missions with waypoints. This version comes with the RC/Servo connectors unsoldered, so you can choose between straight or right-angled ones, both of which are included.



Arduino and ArduPilot Mega 2.5.2 Compatible!

Includes both right angle and straight pins for I/O, allowing user to customize as needed.

Includes 3-axis gyro, accelerometer and magnetometer, along with a high-performance barometer

Onboard 16Mbit Dataflash chip for automatic datalogging

Digital compass powered by HMC5883L chip, included on the main board.

Invensense's 6 DoF Accelerometer/Gyro MPU-6000.

Barometric pressure sensor upgraded to MS5611-01BA03, from Measurement Specialties.

Atmel's ATMEGA2560-16AU and ATMEGA32U-2 chips for processing and usb functions respectively.

The RCTimer Radio telemetry system base on 3DR Radio system and 100% compatible.

It's designed as an open source Xbee replacement radio set, offering a lower price, longer range (approx one mile) and superior performance to Xbee radios. It’s available in 915Mhz ; and in the following configurations:  serial board (for the air) and USB (for the ground).

The system provides a full-duplex link  using HopeRF's HM-TRP modules running custom, open source firmware.  Interface to the module is via standard 5V-tolerant TTL serial / FTDI USB serial.

Firmware upgrades and configuration are fully supported in the APM Mission Planner. Configuration is also possible through the 3DR Radio configurator and AT commands.



GPS CN06 Features:

         ·Standalone GPS receiver

         ·u-blox NEO-6M GPS module

         ·EEPROM for save configuration permanently

         ·Build in 25X25mm active antenna

         ·UART (TTL) port with EMI protection

·Rechargeable battery for backup/hotstart

Default parameter

         ·Baud rate : 9600   

If this GPS receiver used for I2C-GPS NAV Board, it must be changed to baud rate 115200 / update rate 5hz.

Package content

         ·Apm2.5.2 (Arduflyer Soldered Side Pin version)x 1

         ·CN06 V3.1 x 1

         ·RCTimer Radio Telemetry Kit 915Mhz x 1


If you have any questions about this product, submit your questions!

Ask a question

Contact: (Can be phone, email, qq, etc.)
If you have any comments on the product or experience, please share!

Write a Review

Contact: (Can be phone, email, qq, etc.).
Powered by ShopEx v4.8.5 |Gzip disabled